YASKAWA DX200 - Page 1003

Alarm List Alarm Number (4000 to 4999)
Alarm List-782
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4508 SPECIFIED ERROR
(COORDINATE)
0 The specified coordinate
system does not exist.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
1 Designation error of the
master tool coordinate
system. This coordinate
system cannot be used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
2 Designation error of the tool
coordinate system. This
coordinate system cannot be
used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
3 Designation error of the
direction of travel coordinate
system (for a shared function).
This coordinate system
cannot be used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy