YASKAWA DX200 - Page 1004

Alarm List Alarm Number (4000 to 4999)
Alarm List-783
4 Designation error of the any
direction coordinate system
(for a shared function). This
coordinate system cannot be
used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
5 Designation error of the
approximation tool coordinate
system (for a shared function).
This coordinate system
cannot be used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
6 Designation error of the
conveyor coordinate system.
This coordinate system
cannot be used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
8 Designation error of the
COMARC coordinate system.
This coordinate system
cannot be used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
9 Designation error of the power
sensor coordinate system.
This coordinate system
cannot be used.
Setting error (1)Check the following settings.
∙ Check the settings for the coordinate system which can be used.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy