Alarm List
Alarm Number (4000 to 4999)
Alarm List-811
5 The setting for overlap is
incorrect.
(1) For a rectangle, it is
incorrectly set as overlap >
width/2.
(2) For a circle, it is incorrectly
set as overlap > ABS (2π *
radius).
(3) For an ellipse, it is
incorrectly set as overlap > π *
radius +ABS (width/2).
Setting error (1)Check the following settings.
∙ Setting of the overlap data
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
6 The setting for the cutting
speed is incorrect. It is set as
the cutting speed > maximum
linear speed.
Setting error (1)Check the following settings.
∙ Setting of the cutting speed
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
7 Coordinated motion cannot be
used with the Form Cutting
motion.
Setting error (1)Check the following settings.
∙ Do not use the coordinated motion.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
8 Zero or a negative value is set
in the minimum diameter
parameter (S1CxG063) for the
Form Cutting motion.
Setting error (1)Check the following settings.
∙ The setting of the minimum diameter parameter (S1CxG063) for the
Form Cutting motion.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy
To Next Page
Loading...
