YASKAWA DX200 - Page 141

9Error
9.1 Error Message
9-5
9.1.2 Editing
Error No. Data Error Message Contents
1010 - EDIT LOCK mode
1011 - EDIT LOCK is set for this line.
1012 - This line is defined as a comment.
1020 - Enter correct value
1030 - Unauthorized ID No.
1050 - Enter correct date
1060 - Enter correct clock
1061 - Enter correct time The input time value is not correct.
1062 - Values over 0 are not acceptable.
Move to OPERATING TIME screen to
set the values over 0.
The value other than “0” cannot be
input.
1063 - Enter 500000 or less value for
'HHHHHH'.
The value for the time is too big.
1070 - Enter an ID number in 4-8 figures
1080 - Negative value can’t be set
1090 - Enter correct value
(START-END signal no)
1130 - Cannot register variable name in this
job any more.
1140 - No input signals are set.
1141 - Overlapped input signals exist.
1142 - Overlapped output signals exist.
1143 - The signal which cannot be used is
set up.
1150 * There are abnormal values in the file.
1FILE NO.
2 FILE SET STATUS
3 FILE VALID CONDITION
4 ALARM SET
5STOP METHOD
6 Control GROUP
7 Robot range limit:
MONITOR TARGET
8 Robot range limit: COORDINATE
9 Robot range limit:
SHAPE TYPE
10 Range combination: INPUT FILE1,
INPUT FILE2 and OUTPUT FILE
11 Range combination: LOGIC
1151 * Check the numeric value settings.