YASKAWA DX200 - Page 146

9Error
9.1 Error Message
9-10
128 The instruction exceeded the maximum size
2290 - Undefined master JOB
2291 * Undefined SUB Master JOB
1 Sub-master 1
2 Sub-master 2
3 Sub-master 3
4 Sub-master 4
5 Sub-master 5
6 Sub-master 6
7 Sub-master 7
8 Sub-master 8
2292 - Undefined MASTER START JOB
2293 * Undefined SUB START JOB
1 Sub-master 1
2 Sub-master 2
3 Sub-master 3
4 Sub-master 4
5 Sub-master 5
6 Sub-master 6
7 Sub-master 7
8 Sub-master 8
2300 - Cannot teach JOB without group-axis
specification
2310 * Same label exists
XXX Line no.
2340 - Editing data not found
2360 - Cannot create editing area
2370 - Cannot cut/copy NOP and END
instructions
2371 - EDIT LOCK/COMMENT functions
cannot be applied to NOP and END.
2372 - This line cannot be defined as a
comment.
2390 - Wrong group axis selection
2400 - Cannot move in cut & paste editing
2430 - Reverse data not found
2440 - Move C-and W-axis to basic position Laser cutting
Error No. Data Error Message Contents