9Error
9.1 Error Message
9-12
2762 - This operation is not allowed, for axes
detachment has been set.
2763 - Cannot modify, for axes detachment
has been set.
2764 - Cannot insert/modify/delete, for axes
detachment has been set.
2770 - The job includes instructions that
cannot execute reverse paste
2780 - Arithmetic error
2790 - Step exceeding operation range.
2822 - Cannot copy job during jog operation.
2823 - Cannot copy, cut and paste during jog
operation.
2870 - Maximum pressure is not set. The maximum pressure for the gun condition file
is not defined.
2871 - Pulse value and stroke value are not
set correctly.
The gun condition file pulse and stroke are not
properly defined.
2872 - Torque value and pressure value are
not set correctly.
The gun condition file torque and pressure are
not properly defined.
2880 - This group name cannot be changed.
2881 - Same group name exists.
2882 - It's not appropriate group name.
2890 - Max stroke range over.
2891 - 1st Pulse value is not set correctly.
2892 - 1st Stroke value is not set correctly.
2893 - 1st Torque value is not set correctly.
2894 - 1st Pressure value is not set correctly.
2895 - Max Pressurization power exceeding
a set range.
2896 * Pulse value exceeding a set range.
xxx Pulse number
2897 * Stroke value exceeding a set range.
xxx Stroke number
2898 * Torque value exceeding a set range.
xxx Torque number
2899 * Pressure value exceeding a set range.
xxx Pressure number
Error No. Data Error Message Contents
To Next Page
Loading...
