YASKAWA DX200 - Page 178

11 LED Indicator on Circuit Board
11.3 7 SEG-LED Indicator
11-4
11.3 7 SEG-LED Indicator
The following tables show the operating statues for JANCD-YIF01-E/
JANCD-YCP02. The operating statuses are indicated by 7 SEG-LED.
Table 11-1:
[Normal Indication]
Table 11-2: [Error Indication]
Status DX200
YIF01 YCP02
Right after applying the power All 7-SEG indicators light up. (‘8’ + ‘.’ light up.)
During the start-up process Counts up from ‘O’ toward ‘d’.
After starting up normally ‘d’ + ‘.’ blink every one second.
Status DX200
YIF01 YCP02
Normal alarm
occurrence
‘d + ‘.’ blink every one
second.
‘d’, + ‘.’ blink every one
second.
Fatal alarm occurrence The error cause and the address where the error
has occurred are indicated by 7 SEG-LED.
(See the indication spec
1.)
Indication
Spec 1
E.g.: [-]  [0]  [2]  [0]  [0]  : Error cause
[,]  [-]  [0]  [0]  [0]  [0]  [F]  [F]
 [0]  [4] is repeated
: Occurrence
address