YASKAWA DX200 - Page 811

Alarm List Alarm Number (4000 to 4999)
Alarm List-590
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then insert the CF card which inserted original YCP21
board into the new YCP21 board.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4 An error occurred in the
conversion process of
gateway address during the
network service data creation
process of the Ethernet
function.
Setting error (1)Check the following settings.
∙ The DHCP server operation (If the DHCP is used)
∙ The network status (If the DHCP is used)
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then insert the CF card which inserted original YCP21
board into the new YCP21 board.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
5 An error occurred in the
conversion process of DNS
server address during the
network service data creation
process of the Ethernet
function.
Setting error (1)Check the following settings.
∙ The DHCP server operation (If the DHCP is used)
∙ The network status (If the DHCP is used)
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then insert the CF card which inserted original YCP21
board into the new YCP21 board.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy