EasyManua.ls Logo

YASKAWA DX200 - Page 963

YASKAWA DX200
1166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alarm List
Alarm Number (4000 to 4999)
Alarm List-742
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
3 The real-number type variable
is not defined.
Setting error (1)Check the following settings.
Set the number of local variables to be used in the job header.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4 The character-string type
variable is not defined.
Setting error (1)Check the following settings.
Set the number of local variables to be used in the job header.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
5 The robot-axis position-type
variable is not defined.
Setting error (1)Check the following settings.
Set the number of local variables to be used in the job header.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
6 The base-axis position-type
variable is not defined.
Setting error (1)Check the following settings.
Set the number of local variables to be used in the job header.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
7 The station-axis position-type
variable is not defined.
Setting error (1)Check the following settings.
Set the number of local variables to be used in the job header.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4436 LESS THAN 3 STEPS
(CIRCULAR)
Setting error (1)Check the following settings.
Perform teaching so that circulation interpolation steps are continuous
three points or more.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy

Table of Contents

Other manuals for YASKAWA DX200

Related product manuals