Alarm List
Alarm Number (4000 to 4999)
Alarm List-746
5 The value for the unsigned 2-
byte data type variable is less
than the minimum value.
Setting error (1)Check the following settings.
∙ Check the settings for variable, and then correct the job to fall within
the input range of the tag.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
6 The value for the signed 4-
byte data type variable is less
than the minimum value.
Setting error (1)Check the following settings.
∙ Check the settings for variable, and then correct the job to fall within
the input range of the tag.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
7 The value for the unsigned 4-
byte data type variable is less
than the minimum value.
Setting error (1)Check the following settings.
∙ Check the settings for variable, and then correct the job to fall within
the input range of the tag.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
8 The value for the real-number
4-byte data type variable is
less than the minimum value.
Setting error (1)Check the following settings.
∙ Check the settings for variable, and then correct the job to fall within
the input range of the tag.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
14 The value for the character-
string type variable is less
than the minimum value.
Setting error (1)Check the following settings.
∙ Check the settings for variable, and then correct the job to fall within
the input range of the tag.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
32770 The value for the signed 1-
byte data type variable
exceeded the maximum
value.
Setting error (1)Check the following settings.
∙ Check the settings for variable, and then correct the job to fall within
the input range of the tag.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy
To Next Page
Loading...
