In addition, the parameters most likely to be changed are assigned to the group of User Parameters, A2-01 through A2-16.
User Parameters are part of the Setup Group, which provides quicker access by eliminating the need to scroll through multiple
menus.
Refer to Pump Application Presets on page 146 for detailed information on Application Presets.
Setting 6008: Pressure Control
Application Preset for Pressure Control applications. Refer to Pump Application Presets on page 146 for a list of parameters
and default values for this Application Preset.
Setting 6009: Pump Down Level
Application Preset for Pump Down Level applications. Refer to Pump Application Presets on page 146 for a list of parameters
and default values for this Application Preset.
Setting 6010: Geothermal Mode
Application Preset for Geothermal Mode. Refer to Pump Application Presets on page 146 for a list of parameters and default
values for this Application Preset.
Setting 6011: VTC Pressure Mode
Application Preset for VTC Pressure Mode. Refer to Pump Application Presets on page 146 for a list of parameters and
default values for this Application Preset.
Setting 6012: Pivot Panel VTC
Application Preset for Pivot Panel VTC. Refer to Pump Application Presets on page 146 for a list of parameters and default
values for this Application Preset.
Note: 1. This setting is available in drive software versions PRG: 8552 and later.
2. This setting is not available in drive models 4A0930 and 4A1200.
Setting 6013: Advanced Pressure Control
Application Preset for Advanced Pressure Control. Refer to Pump Application Presets on page 146 for a list of parameters
and default values for this Application Preset.
Note: 1. This setting is available in drive software versions PRG: 8552 and later.
2. This setting is not available in drive models 4A0930 and 4A1200.
Setting 6014: Pivot Panel Submersible
Application Preset for Pivot Panel Submersible Control. Refer to Pump Application Presets on page 146 for a list of parameters
and default values for this Application Preset.
Note: 1. This setting is available in drive software versions PRG: 8553 and later.
2. This setting is not available in drive models 4A0930 and 4A1200.
Setting 7770: General Purpose
General Purpose Application Preset. Refer to Pump Application Presets on page 146 for a list of parameters and default values
for this Application Preset.
Setting 7771: Submersible Motor General Purpose Operation
General Purpose Application Preset. Refer to Pump Application Presets on page 146 for a list of parameters and default values
for this Application Preset.
n
A1-08: Custom Initialize Modes
Refer to Parameters Set Depending on A1-08 Setting on page 148 and Refer to Parameters Displayed Depending on A1-08
Setting on page 149 for details.
Note: 1. This parameter is available in drive software versions PRG: 8552 and later.
2. This parameter is not available in drive models 4A0930 and 4A1200.
No. Parameter Name Setting Range Default
A1-08 Custom Initialize Modes 0, 3005, 3006 0
4.7 Basic iQpump Setup and Application Preset Parameters
212
YASKAWA TOEP YAIP1W 01F YASKAWA AC Drive - iQpump1000 User Manual
To Next Page
Loading...
