Programming 5 - 57
A successful COPY of the parameter values will display:
An error may occur while writing the parameter values to the Drive. If an error is displayed, press any key to cancel the error
display and return to parameter o3-01. Error displays and their meanings are covered in
Chapter 6: Diagnostics and
Troubleshooting
of the E7 Users Manual (TM.E7.01).
It is possible to compare the parameter values stored in the digital operator with the parameter values currently in the Drive by
using the VERIFY function. This VERIFY function should not be confused with the “-VERIFY-“ that is displayed on the
digital operator when viewing the “Modified Constants” menu. To VERIFY the parameter values in the Drive as compared
with those stored in the digital operator, set o3-01= “3: OP<-->INV VERIFY”. During the comparing of the parameter values
into the Drive the digital operator will display:
A successful VERIFY of the parameter values will display:
If all the parameter values stored in the digital operator do not match those programmed in the Drive, the digital operator
displays the following:
-
DV-
COPY
OP→INV COPYING
-
DV-
COPY
COPY COMPLETE
-
DV-
VERIFY
DATA VERIFYING
-
DV-
VERIFY
VERIFY COMPLETE
To Next Page
Loading...
