Administrator’s Guide for SIP-T46G IP Phone
160
4. Select the desired value (0-7) from the pull-down list of PRIORITY.
5. Click Confirm to accept the change.
A dialog box pops up to prompt reboot to make the settings effective.
6. Click OK to reboot the IP phone.
To configure VLAN for PC port via web user interface:
1. Click on Network->Advanced.
2. In the VLAN block, select the desired value from the pull-down list of PC Port Active.
3. Enter the VLAN ID in the VID (1-4094) field.
4. Select the desired value (0-7) from the pull-down list of PRIORITY.
5. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after reboot.
6. Click OK to reboot the IP phone.
To Next Page
Loading...
