6-16 IM 760301-01E
• Selecting the Waveform Mapping
4. Press the Wave Mapping soft key to display the Wave Mapping dialog box.
5. Press SET to set the mode to Auto, Fixed, or User. If you selected User,
proceed to step 6.
6. Press the cursor keys to select the input signal you wish to set.
7. Press SET. A box used to set the display position number appears.
8. Press the cursor keys to select a value between 0 and 3.
9. Press SET to confirm the new display position.
When Mode is Auto When Mode is User
6.6 Waveform Display on Divided Windows
To Next Page
Loading...
