YOKOGAWA wt3000 - Page 212

7-6 IM 760301-01E
• Selecting the Item to Be Set
3. Press the Trend Object soft key.
4. Press the cursor keys to select a value between T1 and T16.
• Selecting the Measurement Function
5. Press the Function soft key. The measurement function selection box appears.
6. Press the cursor keys to select any of the measurement functions starting with
U.
7. Press SET to confirm.
• Selecting the Element/Wiring Unit
8. Press the Element/
ΣΣ
ΣΣ
Σ soft key to display the element/wiring unit selection box.
9. Press the cursor keys to select any of the elements/wiring units starting with
Element1.
10. Press SET to confirm.
• Selecting the Harmonic Order (Applicable Only on Models with the Advanced
Computation Option or the Harmonic Measurement Option)
11. Press Order soft key.
12. Press the cursor keys to select the order from --- (normal measured value) and
0 to the maximum measured order (see section 7.5 in the
Expansion Function
User’s Manual
).
To check the trend display settings, use the setup parameter list function (see
section 3.16).
7.3 Selecting the Trend Display Target