8-12 IM 760301-01E
• Stopping the Storage Operation
5. If the storage operation is in progress, pressing STORE again stops the
operation. The STORE key turns OFF.
• Automatically Stopping the Storage Operation
5. The storage operation stops automatically according to the following conditions
depending on the store mode. The STORE key turns OFF.
• During manual mode
The storage operation stops when the specified store count of data is stored
or when the data is stored up to the internal memory size (approx. 30 MB).
“Store:Stop” is displayed in the upper left corner of the screen.
• During real-time mode
The storage operation stops when the specified store count of data is stored,
when the reservation time for stopping the storage operation is reached, or
when the data is stored up to the internal memory size. “Store:Stop” is
displayed in the upper left corner of the screen.
• During integration synchronization mode
The storage operation stops when the specified store count of data is stored,
when integration stops, or when the data is stored up to the internal memory
size. “Store:Stop” is displayed in the upper left corner of the screen.
• Initializing (Clearing) the Internal Memory
The procedure to clear the internal memory varies depending on the store mode. This
section describes the procedures when the store mode is store. For the procedures
when the store mode is recall, see section 8.6.
6. While the storage operation is stopped, press STORE again.
If the alert indication for internal memory initialization (section 8.3) is ON, the Alert
dialog box appears. Proceed to step 7. If the indication is OFF, the data in the internal
memory is cleared without displaying the Alert dialog box.
7. Press the cursor keys to select OK or Cancel.
8. Select OK and press SET to clear the data in the internal memory. Select
Cancel and press SET to not clear the data in the internal memory.
8.4 Storing Data
To Next Page
Loading...
Need help?
General
