9-14 IM 760301-01E
• Extension and Data Size
• During normal measurement
Data Type Extension Data Size (Bytes)
Binary .WVF Approx. (8K + 4 × 1002 × Tw) where Tw is the number of displayed
waveforms
.HDR Approx. 1 K (condition: when there is one displayed waveform)
ASCII .CSV Approx. 15 K (condition: when there is one displayed waveform)
Float .FLD 4 × 1002
• Selecting the Waveform
• When the data type is set to Binary or ASCII, the waveform that is displayed on
the screen is saved.
• When the data type is Float, the waveform of the input signal selected from the
following is saved.
• Only the input signals of the installed elements are applicable for the
selection.
• For models with the motor evaluation function (motor version), the input
signals of Speed and Torque are also selectable items.
• Saving the Numeric Data
Select Numeric from the File Item menu to save numerical data.
• Selecting the Data Type
Select the data type from below. The extension is automatically added. The data
type is fixed to ASCII for the cycle-by-cycle measurement.
• ASCII
• Saved in ASCII format.
• The file can be used on your PC for analysis.
• The file cannot be loaded into the WT3000.
• Float
• Saved in 32-bit floating format.
• The file cannot be loaded into the WT3000.
• Extension and Data Size (Normal Measurement Example)
Data Type Extension Data Size (Bytes)
ASCII .CSV Approx. 2 K (condition: number of elements 1, saved item
Preset1)
Float .WTD When integration is not performed
Approx. (8 K + 4 × Dn)
When integration is performed
Approx. (8K + (4 × Dn + 16 × Ti))
Dn: Number of numerical data to be saved
(Number of measurement functions×(number of elements +
number of wiring units))
Ti: Number of integration time to be saved
9.3 Saving Setup Parameters, Waveform Display Data, Numeric Data, Waveform Sampling Data
To Next Page
Loading...
