To Next Page

To Previous Page

3-24

IM WT5000-02EN

The user-defined function setup screen shows five functions per screen. Up to 20 functions can be

defined. In the setup example, the maximum value of the true rms voltage is set in F1, the maximum

value of the true rms current is set in F2, and the maximum value of the active power is set in F3.

F1: Maximum value of the true rms voltage (element 1) Max Urms1 = MAXURMS(E1)

F2: Maximum value of the true rms current (element 1) Max Irms1 = MAXIRMS(E1)

F3: Maximum value of the active power (element 1) Max P1 = MAXP(E1)

If you set the computation setting to on, maximum values are shown on the measurement display

screen.

Note

• By default, the computed values of user definitions contain samples. Change them as necessary.

• You can also display the computation/output settings overview screen by moving the cursor on the

Computation/Output tab using the arrow keys and then pressing SET.

Switching the Displayed Items (Items)

You can switch the measured value (measurement function) shown in the screen.

Tap Display.

A display format setup screen (Display/Numeric/Graph) appears. For details, see section 3.1.

Tap Items. The following screen appears.

Closes the menu

Set the displayed item.

You can set the following items for displaying maximum values (MAX hold).

Maximum value (User Func group):

F1 to F20 (user-defined function)

Procedure Using the Menu Icons

You can also use the menu icons shown on the right side of the screen to switch the displayed items.

Tap the Display menu icon . A Display menu appears in the sub menu area on the right side

of the screen.

By tapping the displayed items, you can specify the same operation as explained in “Switching the

Displayed Items” described earlier.

Note

For details on the Display menu, see page iv.

3.6 Holding the Maximum Values

YOKOGAWA WT5000 User Manual

Other manuals for YOKOGAWA WT5000