App-2
IM WT5000-02EN
Setup Error Messages (500 to 899)
Code Message Chapter or Section
600 File access failure. —
601 Invalid file name.
Check the file name.
8.2
602, 603 No USB device or no storage media inserted.
Check the USB device connection, and the existence of a storage medium in the drive.
8.1
604 Media failure.
Check the storage medium.
8.1
605 File not found.
Check the filename and the storage medium.
—
606 Media is protected.
Set the disk's(medium's) write protect switch to OFF.
—
607 Media was removed while accessing.
Check the storage medium.
8.1
608, 609 File already exists. —
610 Contains invalid characters. 8.2
611, 612 Media full.
Delete unnecessary file(s) or use another disk.
8.6
613 Cannot delete a directory if there are files in the directory. 8.6
614 File is protected. —
615 Physical format error.
Reformat the medium. If the same error occurs, the instrument is probably unable to
execute a format on this medium.
—
616 to 620,
622 to 641
File system failure.
Check using another disk. If the same message still appears, maintenance service is
required.
—
621 File is damaged.
Check the file.
—
643 to 653,
659, 660
Media failure.
Check the medium.
—
656 Cannot save more than 256 item to the root directory. Change save destination or delete
files/directories from the root directory.
8.2
662 File operation is interrupted. —
663 File unknown format.
Check the file format.
1.5
665 Cannot load this file format.
File was stored on other models or other versions.
—
666 File is now being accessed.
Execute after access is made.
—
668 Cannot load this bitmap file.
Use file of 16bit Color or 24bit Color Mode
with less or equal size 1000x720.
3.7
669 Cannot load this text file.
Confirm the contents of file.
1.5
675 Cannot load this file.
Model/options do not conform.
—
676 Writing prohibited in this file. —
677 An error occurred while network access.
Confirm network conditions.
Chapter 15
690 Cannot execute for the directory depth is 10 or more. —
691 Cannot execute because of source and destination are over lapped. —
692 Cannot execute for the media itself. —
693 Cannot store at Network Drive. 7.3
694 Trigger Event is Off. 3.5
695 File version is new. Update firmware. —
696 The file may be damaged or an unsuccessful file close could have occurred. —
697 Abnormal data file. Unsuccessful finish of file save is detected. —
705 Can not operate while accessing medium.
Wait until access has completed.
—
706 Can not operate during hard copy.
Wait until output has completed.
—
713 Cannot execute for All or User display mode. —
714 Cannot execute for All display mode. —
Appendix 1 Messages and Corrective Actions
To Next Page
Loading...
Need help?
General
