App-3
IM WT5000-02EN
Code Message Chapter or Section
720 Over Run had occurred. —
721 Can not set or execute because store is processing. Try Again. —
722 No target Element for integration execution. 4.1
723 Can not set or execute when Integ Independent Control is on. 4.1
724 Can not set or execute because recording is processing. Try again. —
725 File creation stopped. File size exceeded 2G bytes. —
726 Cannot start integration. In order to start, set Time/div for wave bigger than 0.01 ms. 6.2
750, 751 Unable to connect to the server.
Check the network settings and configuration.
Chapter 15
752 This ftp function in not supported. —
753 FTP Error: Client Handle
Confirm the network settings and connection.
Chapter 15
758 Failed to acquire time from SNTP server.
Confirm the network settings and connection.
15.6
759 Failed to initialize network.
Confirm the network settings.
Chapter 15
760 Cannot execute or set when IEEE 1588 is on. To execute or change this setting, turn off
IEEE 1588.
16.3
761 Cannot execute or set when SNTPs "Adjust at Power On" is on. To execute or change the
setting, turn off "Adjust at Power On".
15.6
762 Cannot execute when IEEE 1588 is not in the "Stable" state. To execute, wait until the state
becomes "Stable" or turn off IEEE 1588.
16.3
800 Illegal date-time.
Set the correct date and time.
3.6*
801 Illegal file name.
The file name contains characters which are not allowed or the file name is not a valid MS-
DOS file name. Enter another file name.
8.2
802 Cannot be set or executed in the Normal measurement mode. —
803 Cannot be set or executed in the IEC Harmonic measurement mode 13.1
812 Cannot be set or executed while storing data. —
813 Cannot be set while integration is running.
Reset Integration.
4.2
814 Cannot be set or executed when NULL is on.
Please turn NULL off.
11.1
820 Cannot be set or executed in the Flicker measurement mode. 14.1
821 Attempt made to start flicker measurement while flicker initialization is not finished. —
822 Attempt made to start flicker measurement while flicker measurement is in progress or
result of flicker judgement is displayed.
—
823 Cannot change during CAL.
Wait until CAL is completed.
11.2
824 Attempt made to initialize flicker measurement while flicker measurement is in progress or
result of flicker judgement is displayed.
—
825 Cannot change limit settings while flicker measurement is in progress. —
826 Cannot be set or executed when flicker measurement is not reset. 14.2
827 Illegal math expression.
Input a correct computing equation.
4.1
828 Cannot start flicker measurement when all periods of dmax measurement are finished. —
829 Cannot judge flicker measurement untill all periods of dmax measurement are finished. —
830 Cannot move period while dmax measurement is not ready. —
831 Processing now.
Retry setting or execution again.
—
841 Attempted to start integration after integration time has reached its preset value. 4.2
842 Attempted to start integration while integration is in progress. 4.2
843 Measurement stopped due to overflow during integration or due to a power failure. 4.2
844 Attempted to stop integration even though integration was not in progress. 4.2
845 Attempted to reset integration even though integration was in progress or integration mode
was not selected.
4.2
846 Attempted to start integration while measurement of peak overflow was in progress. —
847 Attempted to start integration in continuous integration mode when integration preset time
was set to “0”.
4.1
848 Attempted made to start integration in real time counting integration mode when the end
time had already passed.
4.1
* Getting Started Guide, IM WT5000-03EN
Appendix 1 Messages and Corrective Actions
To Next Page
Loading...
Need help?
General
