YSI SonTek ADVField

SonTek/YSI
ADVField/Hydra Operation Manual (September 1, 2001) 39
RecordExtPress [YES|NO] [YES|NO] [YES|NO]
• Default parameters: NO NO NO
• Without parameter: returns its current settings for each burst type.
• When used with from one to three valid parameters, tells the ADV whether to record data
from an optional, external pressure sensor. See §1.3 for a description of burst sampling.
○
YES tells the ADV to record external pressure sensor data for each velocity sample for
the selected burst types.
YES increases the size of each sample by 3 bytes.
○
NO tells the ADV not to record external pressure sensor data for the selected burst types.
• This parameter is used only in deployment mode; it has no affect on real-time data collection.
• If only one or two input arguments are specified, it does not change the settings for the non-
specified burst types.
• Appendix 2 has a description of the data recorded based on the
Record command settings.
RecordCTD [YES|NO] [YES|NO] [YES|NO]
• Default parameters: NO NO NO
• Without parameter: returns its current settings for each burst type.
• When used with from one to three valid parameters, tells the ADV whether to record data
from an optional CTD sensor. See §1.3 for a description of burst sampling.
○
YES tells the ADV to record optional CTD data for each velocity sample for the selected
burst types.
YES increases the size of each sample by x bytes, where x is dependent on the
type of CTD sensor being used.
○
NO tells the ADV not to record CTD data for the selected burst types.
• This parameter is used only in deployment mode; it has no affect on real-time data collection.
• If only one or two input arguments are specified, it does not change the settings for the non-
specified burst types.
• Appendix 2 has a description of the data recorded based on the
Record command settings.
RecordLisst [YES|NO] [YES|NO] [YES|NO]
• Default parameters: NO NO NO
• Without parameter: returns its current settings for each burst type.
• When used with from one to three valid parameters, tells the ADV whether to record data
from an optional LISST-100 sensor. See §1.3 for a description of burst sampling.
○
YES tells the ADV to record optional LISST data for each velocity sample for the se-
lected burst types.
YES increases the size of each sample by 80 bytes.
○
NO tells the ADV not to record LISST data for the selected burst types.
• This parameter is used only in deployment mode; it has no affect on real-time data collection.
• If only one or two input arguments are specified, it does not change the settings for the non-
specified burst types.
• Appendix 2 has a description of the data recorded based on the
Record command settings.