SonTek/YSI
38
ADVField Operation Manual (September 1, 2001)
RecordSensor [YES|NO] [YES|NO] [YES|NO]
• Default parameters:
○ Neither
a temperature or pressure sensor installed:
NO NO NO
○ With temperature and/or pressure sensor installed:
YES YES YES
• Without parameter: returns its current settings for each burst type.
• When used with from one to three valid parameters, tells the ADV whether to record tem-
perature and/or pressure sensor data. See §1.3 for a description of burst sampling.
○
YES
tells the ADV to record temperature and/or pressure data (if either or both are in-
stalled) for each velocity sample for the selected burst types.
YES
increases the size of
each sample by 4 bytes.
○
NO
tells the ADV not to record temperature/pressure data for the selected burst types.
• This parameter is used only in deployment mode; it has no affect on real-time data collection.
• If only one or two input arguments are specified, it does not change the settings for the non-
specified burst types.
• Appendix 2 has a description of the data recorded based on the
Record
command settings.
RecordStat [YES|NO] [YES|NO] [YES|NO]
• Default parameters:
YES YES YES
• Without parameter: returns its current settings for each burst type.
• When used with from one to three valid parameters, tells the ADV whether to record statis-
tics at the end of each burst. See §1.3 for a description of burst sampling.
○
YES
tells the ADV to record several statistics at the end of each burst. The statistics in-
clude the mean and standard deviation values for the following parameters (assuming
appropriate sensors are installed): amplitude and correlation for each receiver, heading,
pitch, roll, temperature, and pressure.
YES
increases the size of each sample by 36 bytes.
○
NO
tells the ADV not to record statistics data for the selected burst types.
• This parameter is used only in deployment mode; it has no affect on real-time data collection.
• If only one or two input arguments are specified, it does not change the settings for the non-
specified burst types.
• Appendix 2 has a description of the data recorded based on the
Record
command settings.
RecordExtSensor [YES|NO] [YES|NO] [YES|NO]
• Default parameters:
NO NO NO
• Without parameter: returns its current settings for each burst type.
• When used with from one to three valid parameters, tells the ADV whether to record data
from an optional, external sensor. See §1.3 for a description of burst sampling.
○
YES
tells the ADV to record external sensor data for each velocity sample for the se-
lected burst types.
YES
increases the size of each sample by 4 bytes.
○
NO
tells the ADV not to record external sensor data for the selected burst types.
• This parameter is used only in deployment mode; it has no affect on real-time data collection.
• If only one or two input arguments are specified, it does not change the settings for the non-
specified burst types.
• Appendix 2 has a description of the data recorded based on the
Record
command settings.