Zebra DS3608 - RTS Line State; Beep on <BEL>

8 - 16 DS3608 Digital Scanner Product Reference Guide
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High
RTS line state.
Beep on <BEL>
If you enable this parameter, the digital scanner issues a beep when it detects a <BEL> character on the RS-232
serial line. <BEL> indicates an illegal entry or other important event.
* Host: Low RTS
Host: High RTS
Beep On <BEL> Character
(Enable)
* Do Not Beep On <BEL> Character
(Disable)