OCR Programming 13 - 13
OCR Maximum Characters
Parameter # 690 (SSI # F1h B2h)
To select the maximum number of OCR characters (including spaces) per line to decode, scan the following bar
code, then scan a three-digit number between 003 and 100 using the bar codes in Appendix G, Numeric Bar Codes
representing the number of OCR characters to decode. Strings of OCR characters greater than the maximum are
ignored. The default is 100.
OCR Subset
Parameter # 686 (SSI # F1h AEh)
Set an OCR subset to define a custom group of characters in place of a preset font variant. For example, if
scanning only numbers and the letters A, B, and C, create a subset of just these characters to speed decoding.
This applies a designated OCR Subset across all enabled OCR fonts.
To set or modify the OCR font subset, first enable the appropriate OCR font(s). Next, scan the following bar code,
then scan numbers and letters to form the OCR Subset from the alphanumeric keyboard in the Advanced Data
Formatting Guide. Then scan
End of Message in the Advanced Data Formatting Guide.
To cancel an OCR subset, for OCR-A or OCR-B, scan OCR-A variant
Full ASCII, or OCR-B variant Full ASCII.
For MICR E13B or US Currency Serial Number, create a subset which includes all allowed characters in that
character set, or scan an option from the Default Parameters on page 4-5 and re-program the digital scanner.
OCR Maximum Characters
OCR Subset
To Next Page
Loading...
Need help?
General
Weight and Dimensions
