Zebra DS3608 - Page 353

Standard Default Parameters A - 5
Baud Rate 156 9Ch 9600 7-12
Parity 158 9Eh None 7-13
Check Parity 151 97h Disable 7-14
Stop Bits 157 9Dh 1 7-14
Software Handshaking 159 9Fh ACK/NAK 7-15
Host RTS Line State 154 9Ah Low 7-16
Decode Data Packet Format 238 EEh Send Raw Decode Data 7-16
Host Serial Response Time-out 155 9Bh 2 sec 7-17
Host Character Time-out 239 EFh 200 msec 7-18
Multipacket Option 334 F0h 4Eh Option 1 7-19
Interpacket Delay 335 F0h 4Fh 0 ms 7-20
Decode Event 256 F0h 00h Disable 7-21
Boot Up Event 258 F0h 02h Disable 7-22
Parameter Event 259 F0h 03h Disable 7-22
RS-232 Host Parameters
RS-232 Host Types N/A N/A Standard 8-6
Baud Rate N/A N/A 9600 8-8
Parity Type N/A N/A None 8-9
Stop Bits N/A N/A 1 Stop Bit 8-10
Data Bits N/A N/A 8-Bit 8-10
Check Receive Errors N/A N/A Enable 8-11
Hardware Handshaking N/A N/A None 8-11
Software Handshaking N/A N/A None 8-13
Host Serial Response Time-out N/A N/A 2 Sec 8-15
RTS Line State N/A N/A Low RTS 8-16
Beep on <BEL> N/A N/A Disable 8-16
Intercharacter Delay N/A N/A 0 msec 8-17
Nixdorf Beep/LED Options N/A N/A Normal Operation 8-18
Ignore Unknown Characters N/A N/A Send Bar Code 8-18
Table A-1 Parameter Defaults (Continued)
Parameter
Parameter
Number
SSI Number Default
Page
Number