Zebra LI4278 - Prefix;Suffix Values

USER PREFERENCES & MISCELLANEOUS SCANNER OPTIONS 5 - 19
Prefix/Suffix Values
Key Category Parameter # P = 99, S1 = 98, S2 = 100
Decimal Value Parameter # P = 105, S1 = 104, S2 = 106
You can append a prefix and/or one or two suffixes to scan data for use in data editing. To set a value for a
prefix or suffix, scan a four-digit number (i.e., four bar codes from Appendix D, NUMERIC BAR CODES) that
corresponds to that value. See Table F-1 on page F-1 for the four-digit codes.
When using host commands to set the prefix or suffix, set the key category parameter to 1, then set the 3-digit
decimal value. See Table F-1 on page F-1 for the four-digit codes.
To correct an error or change a selection, scan Cancel on page D-3.
NOTE To use Prefix/Suffix values, first set the Scan Data Transmission Format on page 5-20.
Scan Prefix
(07h)
Scan Suffix 1
(06h)
Scan Suffix 2
(08h)
Data Format Cancel