USER PREFERENCES & MISCELLANEOUS SCANNER OPTIONS 5 - 23
Unsolicited Heartbeat Interval
Parameter # 1118
The linear imager scanner supports sending Unsolicited Heartbeat Messages to assist in diagnostics. To
enable this feature and set the desired unsolicited heartbeat interval, scan one of the time interval bar codes
below, or scan Set Another Interval followed by four numeric bar codes from Appendix D, NUMERIC BAR
CODES (scan sequential numbers that correspond to the desired number of seconds).
Scan Disable Unsolicited Heartbeat Interval to turn off the feature.
The heartbeat event is sent as decode data (with no decode beep) in the form of:
MOTEVTHB:nnn
where nnn is a three digit sequence number starting at 001 and wrapping after 100.
NOTE For correct operation, you must disable Low Power Mode (see Low Power Mode on page 5-10).
10 seconds
(10)
1 minute
(60)
Set Another Interval
Disable Unsolicited Heartbeat Interval
(0)
To Next Page
Loading...
