Zebra LI4278 - Optional USB Parameters; Ignore Beep; Ignore Bar Code Configuration

USB INTERFACE 8 - 15
Optional USB Parameters
If you configure the linear imager scanner and find the settings were not saved, or changed, when the system
is restarted scan the bar codes that follow to override USB interface defaults.
Scan a bar code below after setting defaults and before configuring the linear imager scanner.
Ignore Beep
The host can send a beep request to the linear imager scanner. When this parameter is enabled, the request is
not sent to the attached linear imager scanner. All directives are still acknowledged to the USB host as if it were
processed.
Ignore Bar Code Configuration
The host has the ability to enable/disable code types. When this parameter is enabled, the request is not sent
to the attached linear imager scanner. All directives are still acknowledged to the USB host as if it were
processed.
*Disable
Enable
*Disable
Enable