Zebra LI4278 - Transmit “No Read” Message

5 - 22 LI4278 Product Reference Guide
Transmit “No Read” Message
Parameter # 94
Scan a bar code below to select whether or not to transmit a No Read message. Enable this to transmit the
characters NR when a successful decode does not occur before trigger release or the
Decode Session Timeout
expires. See Decode Session Timeout on page 5-16. Disable this to send nothing to the host if a symbol does
not decode.
NOTE If you enable Transmit No Read, and also enable Symbol Code ID Character or AIM Code ID Character
for Transmit Code ID Character on page 5-18, the linear imager scanner appends the code ID for Code 39
to the NR message.
Enable No Read
(01h)
*Disable No Read
(00h)