Getting Started 1 - 9
5. When the LED turns off, remove the handstrap.
6. Slide the battery latch to the right. The battery ejects slightly.
Figure 1-8
Removing the Battery
7. Lift the battery from the MC67.
8. Insert the replacement battery, bottom first, into the battery compartment in the back of the MC67.
9. Press the battery down until the battery release latch snaps (2-clicks) into place.
10. Replace the handstrap.
Resetting the MC67
There are three reset functions; warm boot, cold boot, and clean boot. A warm boot restarts the MC67 by
closing all running programs. A cold boot also restarts the MC67, and also initializes some drivers. Data saved
in flash memory or a memory card is not lost.
If the MC67 is not functioning properly, perform a warm boot first. If the MC67 still does not respond, perform a
cold boot.
Performing a Warm Boot
Hold down the red Power button for approximately five seconds. As soon as the MC67 starts to boot release
the Power button.
Performing a Cold Boot
To perform a cold boot:
•
On a numeric and DSD keypad, simultaneously press the red Power button and the and
keys.
•
On a Calculator DSD keypad, simultaneously press the red Power button and the and keys.
•
On an alphanumeric keypad, simultaneously press the red Power button and the and keys.
2
To Next Page
Loading...