Networking Go to Contents
HFA3 Instructions for Use 2660021166131 Rev. A 2018-11
7-10
Wired Printers
To connect directly to a PostScript printer when an HF
A3 is in local database mode:
1. Ensure that the HFA3 has not been connected to a local network.
2. Connect the appropriate cable to the Ethernet port on the instrument (see “The HFA3– Side
Panel Opened,” on page 3-3) and the printer (refer to manufacturer’s instructions).
3. If not already on, turn on the printer and the HFA3 (ensur
e that both devices are plugged in),
and log into the instrument as Administrator.
4. Select Setti
ngs > Network and note the HFA3 IP address. The IP address should be in the
range of 169.254.1.0 – 169.254.1.255 if the instrumen
t has not previously been connected to a
network.
5. To set up the printer on the instrument, follow steps 12.–16. in “Wireless Printers,” on
page 7-8.
Shared Network Printers
To connect to a shared network printer:
1. Verify the IP address of both the HFA3 and the p
rinter to ensure that they are on the same local
network.
2. On the instrument, log in as Administr
ator.
3. To set up the printer on the instrument, follow steps 12.–16. in “Wireless Printers,” on
page 7-8. Ensure in step 14. to select Prin
t server as the Printer connection.
To Next Page
Loading...
Need help?
General
