Troubleshooting Go to Contents
HFA3 Instructions for Use 2660021166131 Rev. A 2018-11
C-2
Test Failed System Encountered a Serious Error. Reboot device, if
problem persists service may be required.
Failed to Run Kinetic Test. You may retry the test and/or
reboot device. If problem persists service may be required.
Failed to Initialize Kinetic Test. You may retry the test and/or
reboot device. If problem persists service may be required.
Failed to Initialize Isopter. You may retry the test and/or
reboot device. If problem persists service may be required.
Failed to run a scan. You may retry the test and/or reboot
device. If problem persists service may be required.
Patient switch unplugged. Verify switch is properly connected
and reboot device. If problem persists service may be
required.
Patient switch not functioning. Replace patient switch.
Test Initialization Failed An error occurred while preparing for test. You may retry the
test and/or reboot device. If problem persists service may be
required.
Ambient light is too high. Please dim room lights and retry.
TLC (Trial Lens Correction) Error TLC is not fully inserted. Please remove and re-insert the TLC
again.
Manual TLC unspecified error. Please remove and re-insert
the Manual TLC again.
TLC is not functioning. Please remove the TLC and use a
different trial lens holder.
Auto TLC unspecified error. Please remove and re-insert the
Auto TLC again.
TLC unspecified error. Please remove and re-insert the TLC
again.
Alert Title Alert Text
Table C-1
To Next Page
Loading...
Need help?
General
