Software Installation
HFA3 Installation Instructions 2660021166131 Rev. A 2018-11
2-2
4. Insert the white USB drive with the SW label, which contains the software update, in
one of the HFA3 USB connections.
Note:
If you get an error message during installation, please take a screenshot (Print
Screen and save in a graphics application, such as Microsoft Paint) of the information,
then call your local ZEISS customer service number, shown on the back of this manual.
5. Navigate to the Main
tenance screen and select Perform update... A confirmation
screen will appear. Select Yes to start.
6. Select Yes to start the Update Wizard.
7. A popup screen appears with the update. Highlight the update and select Run.
To Next Page
Loading...
