HFA3 Instructions for Use 2660021166131 Rev. A 2018-11
Go to Contents Data, Tests & Reports
6-17
Isopter points are connected to form the isopter lines. However, points that define the borders of a
blind spot are not connected to each other. Occasionally an isopter point will appear on the report
that is not connected to other isopter points. This situation occurs when you have retested a
meridian. Only the most recent point on a meridian will be used for the isopter map.
cáÖìêÉ=SKS=háåÉíáÅ=VM=aÉÖêÉÉë
To Next Page
Loading...
