Slate tones
Using slate tones (Slate Tone)
F
Multi Track Field Recorder
11 7
Setting the frequency
3. Use e to select Frequency,
and press E.
4. Use e to adjust the fre-
quency, and press m.
HINT
This can be set from 100 to 10,000 Hz.
Setting the routing
Set the destination for the slate tone signal.
3. Use e to select Routing,
and press E.
4. Use e to select the tracks/outputs for slate tone
signal routing, and press E.
Set all to postfader
Select postfader
Off
Clear all settings
NOTE
Routing to tracks 1–6 is not possible when operating as an
audio interface (Stereo Mix).
HINT
Press
E
to switch between Postfader and Off.
5. Press m.
To Next Page
Loading...
