Chapter 13 Switch Setup
IES-1248-51V User’s Guide
112
Priority 5 Typically used for video that consumes high bandwidth and is
sensitive to jitter.
Priority 4 Typically used for controlled load, latency-sensitive traffic such as
SNA (Systems Network Architecture) transactions.
Priority 3 Typically used for “excellent effort” or better than best effort and
would include important business traffic that can tolerate some delay.
Priority 2 This is for “spare bandwidth”.
Priority 1 This is typically used for non-critical “background” traffic such as bulk
transfers that are allowed but that should not affect other applications
and users.
Priority 0 Typically used for best-effort traffic.
Apply Click Apply to save your changes to the IES-1248-51V’s volatile
memory. The IES-1248-51V loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 16 Switch Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...