ZyXEL Communications IES-1248-51A - Voip Diagnostic Commands

Chapter 68 VoIP Commands
IES-1248-51V User’s Guide
545
68.4 voip diagnostic Commands
Use these commands to perform a variety of standard Metallic Line Tests on the
subscriber ports.
Table 209 voip diagnostic Commands
COMMAND DESCRIPTION P
voip diagnostic mlt test
<port> <option> [force]
This command performs a variety of standard
Metallic Line Tests on the specified connection.
Perform specified MLT test item in specified
subscriber(s)
port: Port number, 1~48
option
: The type or types of test to be run.
Allowed values are:
all: Perform all tests on the line connected
to the specified port.
vac: Test the line’s AC voltage only.
vdc: Test the line’s DC voltage only.
rload: Test the line’s load resistance only.
riso: Test the line’s isolation resistance
only.
cap: Test the line’s capacitance only.
ren: Test the line’s ringer equivalent
number only.
ring: Test the line’s ring voltage only.
metering: Test the line’s metering voltage
only.
dialtone: Test dialtone
digit: Test digit
roh: Test ROH which is a tone sent at the
end of a call to indicate that the other party
has hung up.
user: User input DTMF tone
force:
Perform the test(s) immediately,
even if the specified port is in use.
M/
H
voip diagnostic mlt show
<port>
This command displays the results of the last
Metallic Line Test that was run on the specified
port.
L/L