ZyXEL Communications IES-1248-51A - VLAN Port Show Command Example; VLAN PVID Command Example; VLAN Priority Command Example

Chapter 56 IEEE 802.1Q Tagged VLAN and Isolation Commands
IES-1248-51V User’s Guide
412
56.3.1 VLAN Port Show Command Example
The following example shows the settings for xDSL port 1.
56.3.2 VLAN PVID Command Example
The following example sets the default VID of port 1 to 200.
56.3.3 VLAN Priority Command Example
The following example sets a priority of three for frames (with an IEEE 802.1Q
VLAN tag) that come in on xDSL port 2.
56.3.4 VLAN Set Command Examples
This command adds or modifies an entry in the static VLAN table. Use the switch
vlan show command to display your configuration. An example of a configuration
is shown next.
switch vlan enable <vid> This command enables the specified
VLAN ID in the SVLAN (Static VLAN)
table.
H/H
switch vlan disable <vid> This command disables the
specified VLAN ID in the SVLAN
(Static VLAN) table.
H/H
switch vlan show <vlanlist> This command shows information
about the specified port’s VLAN
settings.
M/L
switch vlan gvrp <portlist>
<enable|disable>
Set the port(s) to enable or disable
GVRP.
H/H
Table 148 IEEE VLAN1Q Tagged VLAN Configuration Command Summary
COMMAND DESCRIPTION P
ras> switch vlan portshow 3
port pvid priority frametype
----- ---- -------- ---------
3 1 0 all
ras> switch vlan pvid 1 200
ras> switch vlan priority 2 3