Chapter 50 How to Access and Use the CLI
IES-1248-51V User’s Guide
367
50.4 Using Shortcuts and Getting Help
This table identifies some shortcuts in the CLI, as well as how to get help.
Use the help command to view the executable commands on the IES-1248-51V.
Follow these steps to create a list of supported commands:
1 Log into the CLI.
2 Type help and press [ENTER]. A list comes up which shows all the commands
available for this device.
50.5 Command Privilege Levels
There is a high, middle or low privilege level for each command.
High privilege commands are only available to administrators with high privilege
access. High privilege commands include things like creating administrator
accounts, restarting the system and resetting the system to its factory defaults.
Administrators with high privilege access can use all commands including the
lower privilege commands.
Administrators with middle privilege access can use middle or low privilege
commands.
Administrators with the low privilege level are restricted to using only low privilege
commands. Low privilege commands are read only.
Table 133 CLI Shortcuts and Help
COMMAND / KEY(S) DESCRIPTION
yz (up/down arrow keys) Scrolls through the list of recently-used commands. You
can edit any command or press [ENTER] to run it again.
? Displays the keywords and/or input values that are
allowed in place of the ?.
help Displays the (full) commands that are allowed in place of
help.
ras> help
adsl alarm config exit
ip statistics switch sys
voip
ras>
To Next Page
Loading...