ZyXEL Communications IES-1248-51A - Static Multicast Commands

Chapter 60 Switch and Statistics Commands
IES-1248-51V User’s Guide
444
60.6 Static Multicast Commands
The following table describes the smcast commands. Use these commands to
configure static multicasting on the IES-1248-51V.
switch rstp maxage <seconds> Sets the IES-1248-51V’s RSTP max age in
seconds.
H/H
switch rstp port disable
<portlist>
Disables RSTP on the specified Ethernet
port(s).
H/H
switch rstp port enable
<portlist>
Enables RSTP on the specified Ethernet
port(s).
H/H
switch rstp port pathcost
<portlist> <pathcost>
Sets the RSTP pathcost of the specified
Ethernet port(s).
H/H
switch rstp port priority
<portlist> <priority>
Sets the RSTP priority of the specified
Ethernet port(s).
H/H
switch rstp port show Displays the RSTP status of the specified
Ethernet port(s).
M/L
switch rstp priority
<priority>
Sets the IES-1248-51V’s RSTP priority. H/H
switch rstp show Display the system’s rstp settings. M/L
statistics rstp Displays rstp information. M/L
Table 168 RSTP Commands (continued)
COMMAND DESCRIPTION P
Table 169 Static Multicast Commands
COMMAND DESCRIPTION P
switch smcast delete <mac-
address>
Removes a static multicast filter entry by
deleting the associated MAC address.
H/H
switch smcast set <xdsl-port>
<mac-address> <join|leave>
Use join/leave to add/ remove multicast
MAC addresses on specified ADSL ports, a
range of ADSL ports or all ADSL ports.
H/H
switch smcast show Displays all MAC addresses linked to ADSL
ports.
M/L