ZyXEL Communications IES-1248-51A - Voip Countrycode Show Command Example

Chapter 68 VoIP Commands
IES-1248-51V User’s Guide
544
68.3.2 voip countrycode show Command Example
An example of using this command is shown next.
ras> voip countrycode show
Country Code : 25,Australia
law : alaw
impedance : 220ohm_820ohm_120nf
loop current : 25 mA
tax type : metering
Ring parameters:
frequency : 25.0 Hz
amplitude : 53.0 Vrms
onTime1 : 0.40 seconds
offTime1 : 0.20 seconds
onTime2 : 0.40 seconds
offTime2 : 2.00 seconds
Pulse parameters:
flashMin : 90 ms
flashMax : 500 ms
breakMin : 47 ms
breakMax : 80 ms
makeMin : 30 ms
makeMax : 55 ms
interDigitMin : 250 ms
Meter parameters:
frequency : 12 kHz
onTime : 200 ms
offTime : 200 ms
Caller ID parameters:
CID type : prior ring
payload type : ETSI-MDMF
first TAS type : DT-AS
second TAS type : NULL
first TAS interval : 300 ms
second TAS interval : 0 ms
start to ring : 400 ms (prior ring only)
Tones parameters:
dial tone : 425Hz -18.0dB continuous
ring back tone : 400+450Hz -18.0dB on 0.400s off 0.200s
busy tone : 425Hz -18.0dB on 0.380s off 0.380s
reorder tone : 480+620Hz -24.0dB on 0.250s off 0.250s
congestion tone : 425Hz -18.0dB on 0.380s off 0.380s
special dial tone : 350+440Hz -13.0dB continuous
call waiting tone #1 : 425Hz -18.0dB on 0.200s off 0.200s
call waiting tone #2 : 425Hz -18.0dB on 0.200s off 4.400s
MWI tone : 350+440Hz -13.0dB on 0.100s off 0.100s
ROH tone : 1400+2060+2450+2600Hz 3.0dB on 0.100s off 0.100s
warning tone : 480+620Hz -24.0dB on 0.250s off 0.250s
480+620Hz -24.0dB on 0.250s
confirmation tone : 600Hz -24.0dB on 0.125s off 0.125s
600Hz -24.0dB on 0.125s