Chapter 62 IP Bridge Commands
IES-1248-51V User’s Guide
452
62.2 IP Bridge Domain Commands
Use these commands to set up and maintain domains in IP bridges.
join|leave Specifies whether you want to add the specified VLAN to (join) or
remove the specified VLAN from (leave) the domain.
ip-address IP address, in dotted decimal notation.
mask-bits Number of bits <1~32> in the subnet mask.
nexthop IP address, in dotted decimal notation.
metric The metric <1~15> represents the “cost” of transmission for routing
purposes. IP routing uses hop count as the measurement of cost, with
a minimum of 1 for directly-connected networks. Select the number
that approximates the cost for this link The number need not be
precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
If two entries have the same metric, the IES-1248-51V uses the one
with the lower IP address.
priority The IEEE 802.1p priority value <0~7>.
port The port number of the PVC.
vpi The VPI of the PVC.
vci The VCI of the PVC.
port-list You can specify a single ADSL port <1>, all ADSL ports <*> or a list of
ADSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
DS vcprofile Assign a VC profile to use for this channel’s downstream traffic shaping.
[,US
vcprofile]
Assign a VC profile to use for policing this channel’s upstream traffic.
The IES-1248-51V does not perform upstream traffic policing if you do
not specify an upstream VC profile.
super|<vlan-
id>
Enable the super channel option to allow a channel forward frames
belonging to multiple VLAN groups (that are not assigned to other
channels). The IES-1248-51V forwards frames belonging to VLAN
groups that are not assigned to specific channels to the super channel.
The super channel functions in the same way as the channel in a single
channel environment. One port can have only one super channel.
The default VID (1 to 4094). Each PVC must have a unique VID since
the IES-1248-51V forwards traffic back to the subscribers based on the
VLAN ID.
You must assign a default VID (1 to 4094) and IEEE 802.1p default
priority (0 to 7) to normal channels. Each PVC must have a unique VID
(since the IES-1248-51V forwards traffic back to the subscribers based
on the VLAN ID).
ipoa|ipoe Specifies whether the PVC is running on Ethernet (ipoe) or on ATM
(ipoa).
Table 173 IP Bridge Command Input Values (continued)
LABEL DESCRIPTION
To Next Page
Loading...