Chapter 51 Common Commands
IES-1248-51V User’s Guide
371
51.3 Configuration Status
Use the config show <sys|sw|adsl|ip|stat|all> [nopause] command to
view the IES-1248-51V’s current configuration.
sys - view system configuration information.
sw - view switch configuration information.
adsl - view ADSL port configuration information.
ip - view IP configuration information.
stat - view statistics.
all - view all the above information.
nopause - view the information without being prompted to continue after each
section.
51.4 Reset to Defaults
Use the following command to reset the IES-1248-51V to the factory defaults.
Make sure you back up your current configuration first (using the web configurator
ras> config show adsl
================= adsl ====================================
================= adsl/show ==================
port enable mode up/downstream profile
---- ------ -------- ------------- -------------------------------
1 V auto 512/ 9088 DEFVAL_MAX
2 V auto 512/ 9088 DEFVAL_MAX
3 V auto 512/ 9088 DEFVAL_MAX
4 V auto 512/ 9088 DEFVAL_MAX
5 V auto 512/ 9088 DEFVAL_MAX
6 V auto 512/ 9088 DEFVAL_MAX
7 V auto 512/ 9088 DEFVAL_MAX
8 V auto 512/ 9088 DEFVAL_MAX
9 V auto 512/ 9088 DEFVAL_MAX
10 V auto 512/ 9088 DEFVAL_MAX
----------------------Snip------------------------
To Next Page
Loading...