ZyXEL Communications IES-1248-51A - Queuemap Commands; RSTP Commands

Chapter 60 Switch and Statistics Commands
IES-1248-51V User’s Guide
443
60.4 Queuemap Commands
The following table describes the queuemap commands. Use these commands to
configure priority levels and physical queues on the IES-1248-51V.
60.5 RSTP Commands
The following table describes the rstp commands. Use these commands to
configure Rapid Spanning Tree Protocol on the IES-1248-51V.
switch enet maxmtu set <size> Sets the MTU (Maximum Transmission Unit)
size for layer 2 frames.
size: 1526 ~ 1532; the default value is
1526.
H/H
switch enet maxmtu show Displays the current MTU size. M/L
switch enet name <portlist>
<name>
Sets the name of the specified Ethernet
port(s).
H/H
switch enet reset <portlist> Resets the Ethernet interface. H/H
switch enet show Displays the Ethernet port settings. M/L
switch enet speed <portlist>
<1000fiber|1000copper|100coppe
r|auto>
Sets the connection speed of the specified
Ethernet port(s).
H/H
statistics enet Displays Ethernet port settings and statistics. M/L
Table 166 Enet Commands (continued)
COMMAND DESCRIPTION P
Table 167 Queuemap Commands
COMMAND DESCRIPTION P
switch queuemap set <priority>
<queue level>
Maps a priority level to a physical queue. H/H
switch queuemap show Displays the system’s priority level to physical
queue mapping.
M/L
Table 168 RSTP Commands
COMMAND DESCRIPTION P
switch rstp disable Turns the IES-1248-51V’s RSTP off. H/H
switch rstp enable Turns the IES-1248-51V’s RSTP on. H/H
switch rstp fwdelay <seconds> Sets the IES-1248-51V’s RSTP forward delay
time in seconds.
H/H
switch rstp hellotime
<seconds>
Sets the IES-1248-51V’s RSTP hello time in
seconds.
H/H