Chapter 53 Alarm Commands
IES-1248-51V User’s Guide
386
53.2 Alarm Commands
The following table describes the alarm commands.
Table 138 alarm Commands
COMMAND DESCRIPTION P
alarm show [<severity>|all]
[<alarm>|all]
[<condition>|all] [detail]
This command displays the current alarms by
severity, alarm category or alarm condition.
detail: Display in-depth alarm information.
L/L
alarm port show
[<severity>|all]
This command displays port alarm severity
level thresholds. The system reports an alarm
on a port if the alarm has a severity equal to
or higher than the port’s threshold.
L/L
alarm port set
<all|enet1|enet2|<port>>
<severity>
This command sets the alarm severity
threshold for recording alarms on an
individual port(s). The system reports an
alarm on a port if the alarm has a severity
equal to or higher than the port’s threshold.
all|enet1|enet2|port: Ports on the IES-
1248-51V.
M/
H
alarm tablelist [<alarm>|all]
[<severity>|all]
[<fac>|all][<target>[,<target>
] [<condition>|all]
This command lists alarm settings.
fac: The log facility (local1~local7) that
has the device log the syslog messages to
different files in the syslog server. See your
syslog program’s documentation for details.
target: snmp|syslog|all The type of alarm
messages that the device is to send (SNMP,
syslog or all).
L/L
alarm history show
[<severity>|all] [<alarm>|all]
[<condition>|all]
[<sdate>|all] [<edate>|all]
[for|rev] [detail]
This command displays historic alarms by
severity, alarm category, alarm condition and/
or dates.
sdate: The start date, in yyyy/mm/dd format.
edate: The end date, in yyyy/mm/dd format.
for|rev: The displaying order. Use for to
display in chronological order starting from
the oldest alarm. Use rev to display in
reverse chronological order starting from the
most recent alarm.
detail: Display in-depth alarm information.
L/~
alarm history clear
[<alarm>|all <condition>|all]
<severity>
This command removes historic alarm entries
by alarm category, alarm condition or
severity.
M/
~
To Next Page
Loading...