ZyXEL Communications IES-1248-51A - IGMP Count Enable Command Example; IGMP Count Set Command Example; IGMP Count Show Command Example; IGMP Snoop Statistics Commands

Chapter 58 IGMP Commands
IES-1248-51V User’s Guide
431
58.5.2 IGMP Count Enable Command Example
The following command turns on the IGMP count limit for port 4.
58.5.3 IGMP Count Set Command Example
The following command sets a IGMP count limit of 2 for port 4.
58.5.4 IGMP Count Show Command Example
The following example displays the IGMP count limit settings for ports 1-5.
58.6 IGMP Snoop Statistics Commands
Use the IGMP Snoop Statistics commands to display current IGMP settings and
statistics.
ras> switch igmpsnoop igmpcount enable 4
ras> switch igmpsnoop igmpcount set 4 2
ras> switch igmpsnoop igmpcount show 1~5
port enable count
---- ------ -----
1 - 5
2 - 5
3 - 5
4 - 5
5 - 5
Table 160 IGMP Snooping Statistics Command Summary
COMMAND DESCRIPTION P
statistics igmpsnoop info [clear] Displays the current IGMP settings and the
number of IGMP-related packets received.
Optionally, clears the statistics.
L/L
statistics igmpsnoop group [<vid>
[<mcast_ip>]]
Displays the information about IGMP groups
learned on the system, specified VLAN, or
specified multicast address on the specified
VLAN(s).
vid: The VLAN ID [1 – 4094].
mcast-ip: The multicast IP address.
L/L
statistics igmpsnoop port info
<portlist>
Displays the number of IGMP-related packets
received on the specified port(s).
L/L