IES-1248-51V User’s Guide
447
CHAPTER 61
IP Commands
This chapter shows you how to use the IP commands to configure the IP (Internet
Protocol) parameters.
61.1 General IP Commands
Use the IES-1248-51V’s management IP addresses to manage it through the
network.
The following table describes the values required for many ip commands. Other
values are discussed with the corresponding commands.
Table 171 General IP Commands Input Values
LABEL DESCRIPTION
ip-address An IP address in dotted decimal notation. For example, 192.168.1.3.
mask-bits The number of bits in an address’s subnet mask. To find the bit number,
convert the subnet mask to binary and add all of the 1’s together. Take
“255.255.255.0” for example. 255 converts to eight 1’s in binary. There
are three 255’s, so add three eights together and you get the bit
number (24).
dest-ip The destination IP address of packets that this static route is to route.
gateway-ip The IP address of the gateway that you want to send the packets
through.
metric The metric (hop count) of a static route.
name A name to identify this static route. Up to 31 ASCII characters. Spaces
and tabs are not allowed.
To Next Page
Loading...