ZyXEL Communications IES-1248-51A - Voip Port Pots Gain Command Example; Voip Port Pots Impedance Command Example; Voip Port Show Command Example; Voip Port H248 Set Command

Chapter 68 VoIP Commands
IES-1248-51V User’s Guide
550
68.6.1 voip port pots gain command Example
The following example shows how to set ports 1 and 2 to use transmission and
receiving gain values as 10 and 8 for voice signal and 5 and 2 for fax and modem
signals.
68.6.2 voip port pots impedance command Example
The following example shows how to set ports 1 and 2 to use
220ohm_680ohm_100nf impedance.
68.6.3 voip port show command Example
The following example shows the current VoIP status of ports 1 and 2.
68.6.4 voip port h248 set Command
The following example sets port 14 to use the DSP_PROFILE_1 profile for voice
calls and DATA_PROFILE_1 for fax and modem calls.
ras> voip port pots gain 1~2 10 8 5 2
ras> voip port pots impedance 1~2 220ohm_680ohm_100nf
ras> voip port show 1~2
port 1:
state : disabled
MG name : MGexample
termination name: term1
dsp profile : asdf
impedance : 220ohm_680ohm_100nf
tx/rx gain : 11/12 in 0.1 dB
port 2:
state : disabled
MG name : MGexample
termination name: ABC
dsp profile : asdf
impedance : 220ohm_680ohm_100nf
tx/rx gain : 11/12 in 0.1 dB
ras> voip port h248 set 14 DSP_PROFILE_1 DATA_PROFILE_1