IES-1248-51V User’s Guide
309
CHAPTER 44
Alarm
This chapter shows you how to display the alarms, sets the severity level of an
alarm(s) and where the system is to send the alarm(s) and set port alarm severity
level threshold settings.
44.1 Alarm
The IES-1248-51V monitors for equipment, DSL and system alarms and can
report them via SNMP or syslog. You can specify the severity level of an alarm(s)
and where the system is to send the alarm(s). You can also set the alarm severity
threshold for recording alarms on an individual port(s). The system reports an
alarm on a port if the alarm has a severity equal to or higher than the port’s
threshold.
44.2 Alarm Status Screen
This screen displays the alarms that are currently in the system.
To open this screen, click Alarm > Alarm Status.
Figure 144 Alarm Status
To Next Page
Loading...