ZyXEL Communications IES-1248-51A - ADSL Commands

Chapter 64 ADSL Commands
IES-1248-51V User’s Guide
470
64.2 ADSL Commands
Use these commands to configure the ADSL ports. See Chapter 16 on page 119
for background information on ADSL..
portlist You can specify a single ADSL port <1>, all ADSL ports <*> or a list
of ADSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
profile A descriptive name for the profile that will define the settings of this
port.
up-downshift-
margin
The upstream down shift noise margin (0~31 dB).
up-max-rate The maximum ADSL upstream transmission rate (32~3000 Kbps).
up-min-margin The minimum acceptable ADSL upstream signal/noise margin
(0~31db).
up-max-margin: The maximum acceptable ADSL upstream signal/
noise margin (0~31db).
up-min-rate The minimum ADSL upstream transmission rate (32~3000 Kbps).
up-target-
margin
The target ADSL upstream signal/noise margin (0~31db).
up-upshift-
margin
The upstream up shift noise margin (0~31 dB).
vlanlist You can specify a single VLAN <1>, all VLANs <*> or a list of VLANs
<1,3,5>. You can also include a range of VLANs <1,5,6~10>.
Table 183 ADSL Command Input Values
LABEL DESCRIPTION
Table 184 ADSL Commands
COMMAND DESCRIPTION P
adsl show <portlist> Shows the activation status, ADSL mode, maximum
upstream and downstream rate settings, profile and
name of each ADSL port.
L/L
adsl enable <portlist> Enables the specified ADSL port(s). M/
H
adsl disable <portlist> Disables the specified ADSL port(s). M/
H
adsl name <portlist><name> Sets the name of an ADSL port(s).
name: A descriptive name for the port. You can use up
to 31 printable ASCII characters (including spaces and
hyphens).
M/
H
adsl reset <portlist> Resets the specified xDSL ports to their defaults. H/H